|Dimensions||3 × 3 × 3 in|
This 90 g weight is made of stainless steel It is used to optimize the balance of your air rifle and can be attached to the entire length of the barrel. (match = runs with an outer diameter of 20 mm Feinwerkbau, Anschütz, Walther, TESRO)
In stock (can be backordered)
|Dimensions||3 × 3 × 3 in|
Available to be ordered. I usually get these in within one week and get them mailed to you soon after.
SCATT WS1 is an electronic training system with a wireless optical sensor for fixed target training. This dry-fire trainer is intended for indoor use. It can be used at real distances from 5 to 10 meters to electronic target frame and simulate dry-fire shooting up to 1000 meters.
The training system comes with an electronic target frame, into which a paper target is inserted (it can be hung on the wall, bullet trap or mounted on a tripod) It connects to the computer without requiring a separate power source. The paper target can be automatically scaled down in the SCATT Software and printed on a regular printer.
Electronic target frame can be used at distances from 5 to 10 meters, allowing you to train in different rooms using a single device. There are red and green light indicators at the top and the bottom of the frame for timed fire practice (e.g. for match pistol shooting).
The wireless optical sensor (model WS-03) mounts on the shooter’s gun. It precisely registers weapon’s alignment during aiming and at the time of the shot (release of trigger). The sensor weighs only 30g (including mounting system) and practically doesn’t affect the gun’s balance. Software allows automatic calibration of the sensor relative to the aiming axis, so there is no need for adjusting the sights of the gun. The sensor compensates rifle cant automatically!
The wireless WS-03 optical sensor has a built-in battery and can be recharged from the USB port of your computer. A full charge requires roughly 1.5 hours. The battery life is approximately 30 hours of continuous aiming (about 10,000 shots with an average time of sighting of 10s). When idle the sensor automatically switches to power saving mode.
You can also connect the optional trigger pressure sensor accessory SCATT WTS to the charging port of the WS-03. It will provide a graph of your trigger pull pressure.
The system comes with modern, user-friendly and functional software – SCATT Professional. It includes all the necessary features for training and analysis at the highest level.
The “cheek piece NJ-carbon” is especially adjustable in 4 dimensions. So you can find the optimal head-position for a perfect sighting!
Carbon feels warm and soft at your cheek and will upgrade your rifle!!
Fits on Anschütz, Walther, Feinwerkbau, Grünig & Elmiger (others by request!)
Glove Size Guide – Used to Measure for all Monard Gloves: Including Junior, Full and Half Finger (to get an accurate size, you need to measure in centimeters) Note: Do NOT pull the tape tight. Round up to the next Centimeter. Pick the high side of the measured value. If you measure and select a glove within the chart, you will get a Glove that is very tight but will go on. If you pick a size larger, you get a little less tight and so on. Use this guide as a starting point.
Example: if you measure and get 24.5 cm, use 25 as your measurement. Since the Large glove is 23-25cm and the XLarge glove is 25-27, I recommend choosing either the XL or XXL glove depending on the fit you like.
Measured Size = Very Tight. Very Hard to get on
Measured Size +1 = Medium Tight, Looser fit, but still a bit hard to get on
Measured Size +2 = Low Tight. Easier to get on